CRF series: steel - centrifugal

Request Information

Power : 50 - 3 000 kW

CRF series cooling tower commercial documentation

CRF series cooling tower technical documentation


  • Closed cooling tower with plate heat exchanger
  • Works without Glycol
  • Full accessories : centrifugal filter, inlets, exogel protection, etc...
  • Counter flow
  • Forced draft centrifugal fan
  • Pulley/Belt transmission
  • Packing: COFINTER high density polyethylene film with vertical channels, deformable for easy cleaning / descaling
  • Multiple fans
  • Single-size units, up to 5 juxtapositions possible


Totally removable and cleanable :
Packing and exchanger
Low-noise towers as standard; can reach 35 dBA at 10 m for 1 MW dissipated
Anti-corrosion protection:
Galvanized steel, X-STEEL stainless steel option corrosion resistance higher than 316 L stainless steel, Elastair 350-micron paint fan casing
Easy servicing :
Fans outside moist air flow, at breast height
Larges rectangular access doors
Packing fully cleanable and easy to descale
Clean and economical technology :
Suppression of chemical discharge on the primary circuit, no glycol necessary: reduced investment and lower power consumption.
Anti-legionella design :
Fully removable, stainless steel plate heat exchanger
Full water flow filtration
Sloped basin: water drained for cleaning
Drain point below the lower level of the basin: full draining
Plane basin: full access and cleaning
Neither welds nor bolting for the casing assembly in contact with water: no biofilm and no corrosion
No water stagnation
Stainless steel recommended to prevent corrosion
Easy upgradable tower :
Soundproofing, power increase


  • HVAC
  • Power generation
Request Information